• New
    BT+WIFI module DALY Smart BMS
    BT+WIFI module DALY Smart BMS
    BT+WIFI module DALY Smart BMS

External WiFi module with Bluetooth for DALY Smart BMS. Take advantage of convenient remote management. Connect the module to the Smart BMS via the UART port.


How to connect DALY Smart BMS with WiFi module

  • Open the SMART BMS app and select "Remote monitoring".
  • To use this function for the first time, you need to register an account.
  • Confirm that the mobile phone and lithium battery are within range of WiFi signals, the mobile phone is connected to the WiFi network and the Bluetooth of the mobile phone is turned on, and then proceed to operate the SMART BMS on the mobile phone.
  • After logging in, select the desired mode from the three modes "single group", "parallel" and "serial" and enter the "Connect Device" interface.
  • In addition to clicking the above three modes, you can also click the "+" in the upper right corner of the device bar to enter the
  • "Connect
  • Device" interface. Click the "+" in the upper right corner of the "Connect Device" interface, select "WiFi Device" in the connection method, and enter the "Discover Device" interface. When the mobile phone finds the WiFi signal of the module, it will appear in the list.
  • Click "Next" to enter the "Connect to WiFi" interface.
  • In the
  • "Connect to WiFi" interface, select the router, enter the WiFi password, and then click "Next", the WiFi module will connect to the router.
  • If the connection fails, the app will prompt you that the addition failed. Check that the WiFi module, mobile phone and router meet the requirements and try again. If the connection is successful, the APP will prompt "Added successfully" and the device name can be reset here and can also be edited in the APP if needed in the future. Click "Save" to enter the first interface function.

8 other products in the same category: